Over 30 Years Experience

The Garden Hardware Experts

Firestone 76mm wide QuickSeam Splice tape - 30.4m roll - W56RAC1603

Stock Availability:
95
SKU:
W56RAC1603
$265.30

Full 30.4m roll. Seam primer is required to prepare the surface of the liner prior to applying this product.

Please watch the Instructional Videos below.

Seaming tape, 75mm wide x 30.4m long. Used for lap jointing of EPDM liner

Also available as a Roll of 7.5m long

Please note:

  • For correct application of this tape you must prepare the mating raw EPDM surfaces with QuickPrime Plus EPDM Seam Primer applied with a Scotchbright type plastic scouring pad or Firestone QuickScrubber Tool. No other primer liquid is permitted.
  • It is critical that the seaming surfaces are not contaminated with sand from the substrate. The use of geotextile underlay or even a 1m wide strip of black builder's plastic under the entire seam if not using underlay will prevent sand contaminants. A rigid board must be dragged along underneath during application if on soft or uneven ground to ensure a solid force can be applied to the seam with the Firestone seam rolling tool.
  • A crayon mark is placed approximately 20mm out from the overlap edge. This means that the placement of the backing tape to this crayon mark will ensure that there is a minimum 5mm of exposed seam tape when the overlap is placed and rolled into position - see in the video below
  • When overlapping Seam Splice tape, Firestone Guidelines suggest the application of a Firestone QuickSeam FormFlash patch along with the use of Firestone Lap Sealant HS over the compromised overlap as may have the potential of a capillary leak - see in the video below
  • Where multiple panels of EPDM meet resulting in a tee or cross intersection of overlapping QuickSeam Splice tape, Firestone Installation Guidelines suggest the application of a Firestone QuickSeam FormFlash patch along with the use of Firestone LapSealant HS over the compromised overlap as may have the potential of a capillary leak - see in the video below

How to apply 76mm QuickSeam Splice Tape

Please note the important detail during the following video time slots:

  • At 1.05 mins, watch tacking of the panels together to eliminate unwanted movement of the panel alignment and reducing possible dust ingress from the substrate.
  • At 1.37 mins, watch the crayon mark positioned 20mm from the overlap edge to allow correct positioning of seam tape later. This enables 5-10mm of seam tape to be exposed on completion of the seam. This means that that there will be no unadhered overlap on completion.
  • At 1.42 mins, watch how primer is used as a temporary tacking of the overlap. This prevents it being inadvertently blown back by wind during the process.
  • At 2.50 mins, see the careful placement of the seam tape's backing tape. It is aligned against the crayon marks.


 

Installing a Firestone QuickSeam FormFlash patch on a QuickSeam Splice Tape overlap


 

Installation of a Firestone QuickSeam FormFlash patch at a T joint of QuickSeam Splice Tape (Option 1). Note there must be at least 75mm coverage from the potential leak spot


 

Installation of a Firestone QuickSeam FormFlash patch at a T joint of QuickSeam Splice Tape (Option 2). Note there must be at least 75mm coverage from the potential leak spots


 

Installation of a Firestone QuickSeam FormFlash patch at a sharp angle-change of a seam. Note there must be at least 75mm coverage from the potential leak spots

Write Your Own Review
You're reviewing:Firestone 76mm wide QuickSeam Splice tape - 30.4m roll - W56RAC1603
Your Rating